Install · Chrome, Edge, Brave, Arc

Six steps, then you never do them again.

SiteGrab is not in the Chrome Web Store, so it installs as an unpacked extension. That takes a minute the first time and leaves the extension without auto-update — the panel tells you when a newer build exists.

Download the current build Get a free key

Loading it

One minute, once

  1. Unpack it somewhere permanent

    Chrome loads the extension from that folder every time it starts, so don't leave it in Downloads.

  2. Open chrome://extensions

    Same address in Edge, Brave and Arc — they all run the same extension.

  3. Turn on Developer mode

    Top right of that page. Chrome disables unpacked extensions whenever this is off, so if SiteGrab goes quiet, check it first.

  4. Press Load unpacked

    Choose the folder you unpacked. SiteGrab appears in the list straight away.

  5. Pin it to the toolbar

    Then open any page you want to capture and press the icon to open the side panel.

  6. Paste your key once

    It activates the browser you are on. The free key below is enough to judge the output.

Free key

Five captures a month,
no card

The key appears on this page immediately — keep it. It is tied to your email, not to a password, and it activates one browser.